you are programming. (See Primary/Alternate Data Formats on page 5-8for further information.)

Step 3. Terminal Type

Refer to Terminal ID Table (page 5-4)and locate the Terminal ID number for your PC. Scan three numeric bar codes on the inside back cover to program the scanner for your terminal ID (you must enter 3 digits). For example, scan 0 0 3 for an IBM PC.

Note: The wildcard for all terminal types is 099.

Step 4. Code I.D.

In the Symbology Chart, beginning on page A-1,find the symbology to which you want to apply the data format. Locate the Hex value for that symbology and scan the 2 digit hex value from the Programming Chart inside the back cover of this manual.

Step 5. Length

Specify what length (up to 9999 characters) of data will be acceptable for this symbology. Scan the four digit data length from the Programming Chart inside the back cover of this manual. (Note: 50 characters is entered as 0050. 9999 is a universal number, indicating all lengths.)

Step 6. Editor Commands

Refer to Data Format Editor Commands (page 5-4). Scan the symbols that represent the command you want to enter. 94 alphanumeric characters may be entered for each symbology data format.

Step 7. Scan Save to save your data format, or Discard to exit without saving

your changes.

Enter Data Format

Save

Discard

5 - 2