Honeywell 1900, 1902 User-SpecifiedAimer Delay, Save, Save, Scanner, Time-Out, Delay Duration, *Off (no delay), 200 milliseconds, 400 milliseconds, Scanner Time-Out

Aimer Delay

The aimer delay allows a delay time for the operator to aim the scanner before the picture is taken. Use these codes to set the time between when the trigger is pulled and when the picture is taken. During the delay time, the aiming light will appear, but the LEDs won’t turn on until the delay time is over. Default = Off.

200 milliseconds400 milliseconds*Off (no delay)User-Specified Aimer Delay

If you want to set your own length for the duration of the delay, scan the bar code below, then set the time-out by scanning digits (0 - 4,000 ms) from the Programming Chart inside the back cover of this manual, then scan Save.

Delay Duration

Scanner Time-Out

Note: Scanner Time-Out applies only to corded scanners. It does not apply to cordless systems.

Scanner Time-Out powers down the scanner after the unit has been idle for the specified time. To prevent the scanner from powering down, set this time-out to

0.Scan Scanner Time-Out, then set the time-out by scanning digits (from 0 - 999,999 ms) from the inside back cover, then scanning Save. Default = 1 ms.

Scanner Time-Out

4 - 16