To put the scanner in multiple scanner mode, scan the bar code below. Once you scan this bar code, the scanner is unlinked from the base or Access Point and must either be placed into the base, or you must scan the Access Point linking bar code in order to relink.

Multiple Scanner Operation

Scanner Name

You may assign a name to each scanner you are using for identification pur- poses. For example, you may want to have a unique identifier for a scanner that is receiving imaging commands sent from the base or Access Point.

The default name for a Xenon is “Xenon.” If you have more than one scanner linked to a base, and they all have the same default name, the first scanner linked to the base receives commands. When renaming a series of scanners with identical default names, unlink all except one of the scanners from the base.

Perform the rename operation using either the bar codes on page 3-23, or by sending the serial command :Xenon:BT_NAMname. where name is the new name for the scanner. If you wish to change the names of additional scanners, link them one at a time and repeat the :Xenon:BT_NAMname. command for each scanner.

3 - 22