Honeywell 1900, 1902 Auto Reconnect Mode, Event, Auto Reconnect On, Auto Reconnect On, Auto Reconnect Off, Auto Reconnect Off, * Auto Reconnect On

Auto Reconnect Mode

Auto Reconnect controls whether or not the scanner automatically begins the relink process when a loss of connection is detected. When the Auto Reconnect On bar code is scanned, the scanner begins the relink process immediately, without user intervention. Default = Auto Reconnect On.

* Auto Reconnect OnAuto Reconnect Off

Note: If you are connecting to a Bluetooth Interface Module, set Auto Reconnect to Off.

The table below shows the results of the Auto Reconnect On and Off set- tings:

Event	Auto Reconnect On	Auto Reconnect Off
Scanner out of	Relink occurs	The scanner is
range	automatically. If	relinked by pulling the
	maximum number of link	trigger, or scanning
	attempts is	the Access Point
	unsuccessful, then the	linking bar code.
	scanner must be
	relinked by either pulling
	the trigger, placing the
	scanner in the base, or
	scanning the Access
	Point linking bar code.
	(See Maximum Link
	Attempts on page 3-29.)
Base or Access	Scanner behaves as if	No attempt to relink
point reset	out of range.	made while base or
(firmware upgrade		Access Point is
or power cycle)		powered off. Trigger
		must be pulled to
		initiate relinking.

3 - 28