Honeywell 1900, 1902 To Add an Output Sequence, Other Programming Selections, F F, Save, 3.Length, •Discard, 2.Code I.D, Enter Sequence, 4.Character Match Sequences

To Add an Output Sequence

1.Scan the Enter Sequence symbol (see Require Output Sequence, page 4-25).

2.Code I.D.

On the Symbology Chart on page A-1,find the symbology to which you want to apply the output sequence format. Locate the Hex value for that symbology and scan the 2 digit hex value from the Programming Chart (inside back cover).

3.Length

Specify what length (up to 9999 characters) of data output will be acceptable for this symbology. Scan the four digit data length from the Programming Chart. (Note: 50 characters is entered as 0050. 9999 is a universal number, indicating all lengths.) When calculating the length, you must count any programmed prefixes, suffixes, or formatted characters as part of the length (unless using 9999).

4.Character Match Sequences

On the ASCII Conversion Chart (Code Page 1252), page A-4,find the Hex value that represents the character(s) you want to match. Use the Programming Chart to read the alphanumeric combination that represents the ASCII characters. (99 is the Universal number, indicating all characters.)

5.End Output Sequence Editor

Scan F F to enter an Output Sequence for an additional symbology, or Save to save your entries.

Other Programming Selections•Discard

This exits without saving any Output Sequence changes.

4 - 22