Data

The new value for a menu setting, identified by the Tag and Sub-

 

Tag.

Storage

A single character that specifies the storage table to which the

 

command is applied. An exclamation point (!) performs the com-

 

mand’s operation on the device’s volatile menu configuration table.

 

A period (.) performs the command’s operation on the device’s

 

non-volatile menu configuration table. Use the non-volatile table

 

only for semi-permanent changes you want saved through a power

 

cycle.

Query Commands

Several special characters can be used to query the device about its settings.

^

?

*

What is the default value for the setting(s).

What is the device’s current value for the setting(s).

What is the range of possible values for the setting(s). (The de- vice’s response uses a dash (-) to indicate a continuous range of values. A pipe () separates items in a list of non-continuous val- ues.)

:Name: Field Usage (Optional)

This command returns the query information from the image scanner.

Tag Field Usage

When a query is used in place of a Tag field, the query applies to the entire set of commands available for the particular storage table indicated by the Storage field of the command. In this case, the SubTag and Data fields should not be used because they are ignored by the device.

SubTag Field Usage

When a query is used in place of a SubTag field, the query applies only to the subset of commands available that match the Tag field. In this case, the Data field should not be used because it is ignored by the device.

Data Field Usage

When a query is used in place of the Data field, the query applies only to the specific command identified by the Tag and SubTag fields.

Concatenation of Multiple Commands

Multiple commands can be issued within one Prefix/Storage sequence. Only the Tag, SubTag, and Data fields must be repeated for each command in the sequence. If additional commands are to be applied to the same Tag, then the new command sequence is separated with a comma (,) and only the SubTag and Data fields of the additional command are issued. If the additional command requires a different Tag field, the command is separated from previous commands by a semicolon (;).

12 - 2