If you select Use Authentication, you will also be asked to enter a passkey for the Mobility Systems device. The PIN entered for the Mobility Systems device must match the one configured on the image scanner. Once you select the 4820i device in Step 13 (page page 3-18), the following screen appears.

1.In the Bluetooth Passkey box, enter the image scanner’s PIN code. The same Bluetooth passkey (PIN code) is required for each device.

2.Tap Reply.

Starting ScanWedge

Once the image scanner is linked to the Mobility Systems device, you need to configure ScanWedge for the correct COM port and then start ScanWedge. For additional information, refer to the Honeywell Powertools User’s Guide, which can be downloaded from www.honeywell.com/aidc.

Out-of-Range AlarmDuration

If your image scanner is out range of the base, an alarm sounds from both your base and image scanner. To activate the alarm options for the image scanner or the base and to set the alarm duration, scan the appropriate bar code below

3 - 20