The Aimer Beam Delay allows a delay time for the operator to aim the reader before the standard illumination and decoding starts. The quickset codes sets the time between when the trigger is pulled and when the decode starts to either 1 or 2 seconds. During the delay time, the aiming beam appears, but the illumination LEDs won’t turn on until the delay time is over.
* Off (no delay)
1 second
2 seconds
If you want to set your own length for the duration of the delay, scan the bar code below, then set the
Delay Duration
Aimer Mode (Aimer Beam option only)If you are reading codes in applications that exhibit high ambient light, you can turn on the aimer beam to assist you in reliably finding and scanning a code. Select Off if you don’t want to use the aimer beam.
Off
* On
3 - 7