Honeywell 42011076-003 manual Entering Installer Mode, HC60NG Receiver Box Fail-Safe Mode Setup

4.1 Entering Installer Mode

1 2

DAY

COPY

DAY

DATE

OFFPROG

AUTO

MAN

OFF

CM9271..6

	Move the slider switch to the OFF mode.					The unit will display the first parameter of installer
						parameter group category 1 (from Parameter n.1
	Press and hold the		button and the two	&
						to n.19) as shown
	buttons together.
3	Press the	or	to		4
						Press the green
	change factory setting.					button to confirm the
	The display will flash					change.
	indicating that a change					The display will stop
	has been made.					flashing.
5	Press	button to go			6	Press	button to go to Installer parameter group
						category 2 ( ) (from Parameter n.1 to n.14).
	to the next parameter.
					7	To exit the installer mode, move the slider switch to
						the AUTO or MAN positions.

4.2 HC60NG Receiver Box Fail-Safe Mode Setup

The failsafe mode defines the receiver box output relay status if the RF communication is lost (e.g. when the room thermostat stops communicating due to discharged batteries). The factory setting keeps the relay permanently off when communications is lost. If this factory setting needs to be changed follow the instructions below:

1.Enter Installer mode as described above.

2.Press the button to enter category 2 parameters.

3.Select the parameter 7:LC by pressing the button.

4.Select the fail-safe mode by pressing or buttons:

•0 - when RF communication is lost the relay will be held in OFF position.

•1 - when RF communication is lost the relay output will cycle at 20% on 80% off.

5.Press the green button to accept the change.

6.Attach appropriate label to the receiver box to indicate the selected fail-safe mode.

IMPORTANT: To enable the frost protection when RF communication is lost, select the fail-safe mode 1. For systems with separate frost protection thermostat or where frost protection is not required select fail-safe mode 0.

Installation Guide