Honeywell 512, 18 manual Quick Menu, Modify Name, Time Zone Galaxy 60, 128, 500, 504 and

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿ ￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿-￿￿7!￿￿￿￿&'(￿)*￿￿￿￿￿￿￿￿￿￿￿￿!￿￿￿#￿##.￿￿￿￿￿￿￿￿￿￿￿￿!￿"""""""$$￿￿￿￿￿￿￿￿￿￿￿￿￿%%+,￿￿￿￿￿￿￿"￿￿￿/.￿￿￿￿

￿￿5￿￿￿0￿￿￿￿$0￿￿2￿3￿&&￿￿#!￿0￿340￿￿￿#.1%￿￿￿￿￿￿￿￿6￿ ￿￿￿

• Quick Menu

All user codes default to the quick menu. This menu is made up of a selection of ten options (0 – 9) from the menu options 11 – 68. The user code level controls access to the quick menu. Any user can be upgraded from the quick menu to the full menu by assigning a * to the user while the Modify Level option is accessed. Therefore a user with a level *5 would have access to the full menu from options 11 – 39. No code can access both menus.

Note: The manager code defaults to the quick menu on the Galaxy 8 and 18, but defaults to the full menu on the Galaxy 60, 128, 500, 504 and 512.

Modify Name

This allows a name to be assigned to the user (maximum 8 characters). Each of the user codes default to the name USER and the manager defaults to MGR. The manager name cannot be changed. On selecting the Modify Name option, a section of the alpha-numeric that can be assigned to the user name is displayed on the bottom line of the keypad; the cursor flashes on the letter L. Press * to erase the letters of the default or previous name. When the previous name has been erased, use the A> or <B keys to move the cursor to the first letter of the name and press the ent key. The selected character appears on the top line, continue this process until the name is completed. The # key toggles between upper and lower case characters and the system library. Press esc to save the name and exit.

Time Zone (Galaxy 60, 128, 500, 504 and 512)

Managers can allocate time zones to user PINs when TIMERS have been programmed by the engineer. Time zones are used to disable the user PIN during the times (ON to OFF) programmed in TIMER A and B.

When 4 = TIME ZONE displays, press the ent key . Using the A> key select the time zones option to be allocated to the PIN. The following time zones options are available:

0=OFF 1=TIMER A 2=TIMER B 3=TIMER A+B

The times assigned to Timer A and Timer B can be viewed using option 45 Timer Control. No access will be granted if a code, assigned to 1=Timer A, 2=Timer B or 3= Timer A+B is entered out with the assigned times, an Illegal Code event is recorded in the log and any

outputs programmed as Illegal Code are activated. 19