Honeywell 128, 500, 504, 512, 60 manual Other Keypad In Use Galaxy 8 And 18 Only

ALARM￿￿￿￿￿￿￿￿￿￿￿AND HELP MESSAGES

	Other Keypad In Use (Galaxy 8 And 18 Only)
	This message advises the user that the system is already in use. The Galaxy 8 and 18
￿￿￿￿￿￿￿￿	allow only one user at a time.
	Alarm In Progress
	The system is currently in alarm condition and must be cancelled by a valid PIN or
	code.
￿￿￿￿￿￿￿￿￿￿￿￿￿
￿￿￿￿￿￿￿￿￿￿￿￿￿	keyswitch operation.
	Pa Reset Required
	After a PA (Personal Attack) zone has been activated, the system has to be reset by
	a high level code (such as a manager or engineer depending on the reset level
	setting).
	Manager Reset Required
	Following an alarm activation, the system requires to be reset by a manager level
	This message is displayed when a tamper alarm occurs.
￿￿￿￿￿￿￿￿￿	Engineer Reset Required
	The system has been programmed for engineer reset following an alarm activation.
	The engineer must be called to reset the system before the user can set the
	alarm.Tamper alarms usually require an engineer to visit the site to check all
	modules on the system.
￿￿￿￿￿￿￿￿￿￿￿
	Invalid Selection
	No Entries
￿￿￿￿￿￿￿	This message appears if a user attempts to view or inspect the log and there is
	nothing in the log to be viewed or when the omit option is selected and there are no
	omittable zones on the system.
	The option selected or value entered is illegal or out of range.
	Invalid Code
￿￿￿￿￿￿￿￿￿
	The code entered is not a valid code registered in the system memory.
	Option Not Available
￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿	This option is provided by the engineer, where it is specifically required. Attempt-
	ing to select an option when it has not been provided results in the display of
	Technistore Reset
	Call the Alarm Monitoring Station and quote the five digit number displayed. Enter
	the number quoted by the monitoring station to reset the system.
￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
	No Modules Added
	When exiting Engineer Mode the panel does not detect the change in the number
	of modules. Press esc to continue.

28