1

MX7 Tecton Agency Compliance

MX7 Tecton mobile computers meet or exceed the requirements of all applicable standards organizations for safe operation. However, as with any electrical equipment, the best way to ensure safe operation is to operate them according to the agency guidelines that follow. Read these guidelines carefully before using your MX7 Tecton.

This documentation is relevant for the following models: Tecton, TectonCS.

Caution:

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. The battery should be disposed of

!

by a qualified recycler or hazardous materials handler. Do not incinerate the battery or dispose of the battery with

general waste materials.

Laser Warnings

•Do not look into the laser’s lens.

•Do not stare directly into the laser beam.

•Do not remove the laser caution labels from the Tecton.

•Do not connect the laser bar code aperture to any other device. The laser bar code aperture is certified for use with the MX7 Tecton only.

Caution: Laser radiation when open. Read the caution labels. Use of controls, adjustments or performance of procedures other

!than those specified herein may result in hazardous radiation exposure.

Laser Label Location

If the following label is attached to your product, it indicates the product contains an engine with a laser aimer:

AVOID EXPOSURE - LASER RADIATION ISEMITTED FROMTHIS APERTURE.

EN60825-1:2007 IEC60825-1:2007

COMPLIES WITH 21 CFR 1040.10 AND 1040.11

LASER LIGHT - DO NOT STARE INTO BEAM

CLASS 2 LASER PRODUCT 1.0mW - 630 - 680nm

Laser Safety Statement

This device has been tested in accordance with and complies with IEC60825-1 ed2 (2007). Complies with 21 CFR 1040.10 and 1040.11, except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007.

LASER LIGHT, DO NOT STARE INTO BEAM, CLASS 2 LASER PRODUCT, 1.0 mW MAX OUTPUT: 630-680nM.

Model Number and Serial Number Labels

The model (item) number and serial number for the terminal are located on labels affixed to the back of the terminal.

FCC Part 15 Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference.

2.This device must accept any interference received, including interference that may cause undesired operation.

1 - 1