Using a Desktop Cradle

Introduction

Note: When an external power supply is used to power this cradle, the external power supply should be UL Listed, with LPS or Class 2 outputs rated 12V, minimum 2 amps.

The desktop cradle is available in three configurations:

1.Without a power supply. A power supply must be ordered separately.

2.With a power supply and a US power cord.

3.With a power supply but without a power cord. A country specific power cord must be provided. Communications cables for the MX7 Tecton are available separately.

Quick Start - Desktop Cradle

The following list outlines, in a general way, the process to follow when preparing the MX7 Tecton desktop cradle for use. Refer to the following sections in this document for more details.

1.Refer to Installing and Removing the Docking Bay Adapter Cup (page 14-7).

2.Connect the cradle end of the power adapter cable to the Power port on the back of the cradle.

3.Attach the AC power connector to a dependable power source.

4.Attach any desired external cabled devices to the ports on the cradle.

5.The desktop cradle is ready for use.

Battery Charging in a Desktop Cradle

The MX7 Tecton main battery recharging is managed by the Power Management settings in the MX7 Tecton. Refer to the Power control panel on the MX7 Tecton.

The spare battery in the spare battery well re-charges with or without an MX7 Tecton in the dock. The spare battery is fully charged in approximately four hours.

The cradle must be receiving power from an external power source before the main battery in the docked MX7 Tecton or spare battery pack charging can take place.

14 - 3