Problem | Cause | Solution |
|
|
|
LED is flashing RED at any | The battery pack voltage has not | Contact Technical Assistance (page |
pocket. | reached 6.0V within 30 minutes and | pack replacement options. |
| the charger has timed out. |
|
|
|
|
Solid YELLOW / AMBER LED | The battery pack is too hot or too | Remove battery pack from the charging pocket and allow |
when battery pack is inserted | cold to charge. | it to adjust to room temperature. |
in the charging pocket. |
| Note: If the battery pack is left in the charging pocket, it |
|
| will cool down or warm to a temperature upon |
|
| which the charger will begin the charge cycle. |
|
| However, depending on the temperature of the |
|
| battery, it may take |
|
| down / |
|
| if the battery is not in the charging pocket. |
|
|
|
Charger Cleaning, Storage and Service
Cleaning
Unplug the charger from the power source before cleaning or removing debris from charging pockets.
Use only mild detergent with a slightly damp cloth to clean the outside of the charger. Do not use solvents or flammable cleaners. Allow the case to dry fully before using again.
Do not allow cleaning agents of any kind to contact the charging contacts; they may be damaged. If necessary, clean them with a
Storage
Remove all batteries from the charging bays and disconnect AC power before placing the charger in storage. It should be stored in a cool, dry place, protected from weather and airborne debris.
Battery packs should be kept in a cool, dry place whenever possible. Do not store battery packs in direct sunlight, on a metal surface, or anywhere the battery pack cannot cool down. Do not leave the battery pack in a
Service
There are no user serviceable parts in the rechargeable Lithium Ion battery or the charger. Contact Technical Assistance (page
13 - 8