To Assign, Change,or DeleteUser CodesVoice Module

SECUR1l’Y CODES

1.Enter your Master code and press the CODE key,

2.Enter single-digit User Number for whom a code is to be assigned, changed, or deleted.

3.If assigning or changing a user’s code, enter the desired 4-digit code for use by that User Number. The console will beep once.

/f deleting a user’s code, perform steps 1 and 2 and then stop. In a few moments the console will beep once, indicating that the existing code has been deleted.

Important:

●Instruct other users to enter their codes carefully to avoid accidentally entering the Duress code. If desired, other users can be assigned a code ending in “9”,to prevent accidental Duress code entry.

. Temporary users should not be shown how to use any system function they do not need to know (e.g., bypassing protection zones).

●Be sure user codes do not conflict with any Duress code.

If your system includes a voice module it will permit you to access the system via a Touch-tone phone, either on-premises or by call-in when away. You can:

●Receive voice messages over the phone regarding system status.

. Arm and disarm the system and perform most function commands.

Complete information regarding the use of this feature is provided in a separate manual: Phone Access User’s Guide that accompanies the voice module.

Notes: . To turn off an alarm (with any system), enter: Security Code + [l/OFF] key.

●The “CALL-IN TAMPER” (“Cl”) console display and logic described in the guide is not present in your system.

●The Relay Command Mode described in the guide is not active with your system, but output relay actions may still be controlled if installer-programmed.

-11-