Horizon Fitness E401 manual Open Hardware BAG for Step, Repeat on other side

INTRODUCTION IMPORTANT

PRECAUTIONS

ASSEMBLY

BEFORE

YOU BEGIN

ELLIPTICAL

OPERATION

CONDITIONING TROUBLESHOOTING HORIZON

GUIDELINES & MAINTENANCE WARRANTY



A S S E M B LY STEP 2
BOLT (A)	CONSOLE MAST
SPRING WASHER (B)
FLAT WASHER (C)	CONSOLE MAST BOOT
TOP FRONT COVER	CONSOLE WIRES
	TOP BACK COVER
	MAIN FRAME

AOpen HARDWARE BAG FOR STEP 2.

BCarefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the

CONSOLE MAST.

CAttach the CONSOLE MAST to the MAIN FRAME using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4 FLAT WASHERS (C).

DInsert the TOP FRONT COVER, followed by the TOP BACK COVER and snap them together.

ESlide CONSOLE MAST BOOT down to seal the console mast hole.

DO NOT PINCH WIRES!

HARDWARE BAG FOR STEP 2 CONTENTS :

#0-5 "	413*/( 8"4)&3 #	'-"5 8"4)&3 $
 NN	 NN	 NN
2UZ 	2UZ 	2UZ 

A S S E M B LY STEP 3
		UPPER HANDLEBAR
	NOTCH
CONSOLE MAST		PRE-ATTACHED
	TAB	SET SCREWS
		PRE-ATTACHED
		BOLT & WASHER
	LOWER HANDLEBAR

NOTE: There is NO hardware bag for this step. All hardware is pre-installed.

ARemove PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.

BSlide LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLT &

WASHERS.

CSlide UPPER HANDLEBARS onto LOWER HANDLEBARS and align NOTCH with TAB making sure handlebars are joined together completely. Secure UPPER HANDLEBARS to LOWER HANDLEBARS using PRE-ATTACHED SET SCREWS.

DRepeat on other side.

After handlebars are assembled they will rotate freely – be cautious. Until the machine is fully assembled, do not grab the handlebars for support.



IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

ELLIPTICAL OPERATION

HORIZON TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES

E401_Rev.1.5.indd 8-9 2/29/08 10:05:32 AM