INTRODUCTION IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
CONDITIONING GUIDELINES
A S S E M B LY STEP 4 |
PEDAL ARM TUBE |
TEFLON WASHERS (E) |
FLAT WASHER (F) |
BOLT (G) |
LINK ARM BRACKET |
SPACER (D) |
LOWER LINK ARM |
PEDAL ARM |
AOpen HARDWARE BAG FOR STEP 4.
BAlign the bracket on the LEFT LOWER LINK ARM with the tube on the LEFT PEDAL ARM.
CSlide the SPACER (D) through the LINK ARM BRACKET and the PEDAL ARM so it can’t rotate.
DInsert 2 TEFLON WASHERS (E) between the PEDAL ARM and the LINK ARM BRACKET.
ESecure the joint with a FLAT WASHER (F) and BOLT (G).
FRepeat on the other side.
A S S E M B LY STEP 5 |
|
|
| LOWER LINK ARM | LOWER |
|
| HANDLEBAR |
| TEFLON WASHERS |
|
| SPACER | |
| LOWER HANDLEBAR | BOLT (J) |
GUIDE RAIL | NUT (K) |
|
|
| |
|
| SPACER (H) |
LOWER LINK ARM | TEFLON WASHERS (I) |
|
AOpen HARDWARE BAG FOR STEP 5.
BSlide SPACER (H) into LOWER LINK ARM.
CPlace TEFLON WASHERS (I) on either side of SPACER (H). While holding TEFLON WASHERS (I) slide LOWER LINK ARM into bottom end of LOWER HANDLEBAR.
DInsert BOLT (J) into LOWER HANDLEBAR and secure using NUT (K).
ERepeat on other side.
HARDWARE BAG FOR STEP 5 CONTENTS :
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
CONDITIONING GUIDELINES
TROUBLESHOOTING HORIZON & MAINTENANCE WARRANTY
10
HARDWARE BAG FOR STEP 4 CONTENTS :
FLAT WASHER (F) 35 mm
Qty: 2
SPACER (D) | TEFLON WASHER (E) |
Qty: 2 | 30 mm |
| Qty: 4 |
BOLT (G)
15mm Qty: 2
SPACER (H) | TEFLON WASHER (I) | |
44 mm | 28.4 mm | |
Qty: 2 | Qty: 4 | |
BOLT (J) | NUT (K) | |
INSIDE DIAMETER: | ||
60 mm | ||
8 mm | ||
Qty: 2 | ||
Qty: 2 | ||
|
11
HORIZON TROUBLESHOOTING WARRANTY & MAINTENANCE
E401_Rev.1.5.indd | 2/29/08 10:05:37 AM |
