INTRODUCTION IMPORTANT PRECAUTIONS

P R E - A S S E M B LY

DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill from

WARNING packaging until specified to do so in the assembly instructions. Failure to do so may

result in injury! Remove plastic wrap from console masts.

Note: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before

completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware. Any grease, such as lithium bike grease is recommended.

A S S E M B LY STEP 2

HARDWARE BAG 2 CONTENTS :

BOLT (D)

FLAT WASHER (E)

WAVY WASHER (F)

LOCK LATCH PIN (G)

Qty: 1

27 mm

29 mm

Qty: 1

 

Qty: 1

Qty: 1

 

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

ASSEMBLY STEP 1

HARDWARE BAG 1 CONTENTS :

BOLT (A)

FLAT WASHER (B)

TEFLON WASHER (C)

15 mm

20 mm

18 mm

Qty: 1

Qty: 1

Qty: 1

BOLT (D)

FLAT WASHER (E)

WAVY WASHER (F)

Qty: 1

27 mm

29 mm

 

Qty: 1

Qty: 1

MAIN FRAME

LEFT CONSOLE MAST

WAVY WASHER (F)

FLAT WASHER (E)

BOLT (D)

MAIN FRAME

RIGHT FOLDING FRAME

LOCK LATCH PIN (G)

A Open Hardware Bag 2.

LEAD WIRE

RIGHT CONSOLE MAST

CONSOLE CABLE

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

CONDITIONING TROUBLESHOOTING LIMITED GUIDELINES & MAINTENANCE WARRANTY

LEFT LINKAGE ARM

 

BOLT (A)

ELEVATION FRAME

FLAT WASHER (B)

 

TEFLON WASHER (C)

 

AOpen HARDWARE BAG 1.

BCut banding straps. Do not move or lift treadmill from packaging.

CMove left linkage arm into position. Insert 1 bolt (A) and 1 FLAT WASHER (B) into left linkage arm followed by 1 teflon washer (C) and attach to elevation frame.

DLift left console mast into upright position. Be sure to hold the console mast firmly, as it will not stay in the upright position on its own.

EInsert 1 bolt (D) and 1 FLAT washer (E) through left console mast followed by 1 WAVY washer (F) and attach to MAIN FRAME.

BAttach LOCK LATCH PIN (G) into RIGHT FOLDING FRAME using T-wrench and tighten completely.

CPull LEAD WIRE through RIGHT CONSOLE MAST. After pulling the lead wire through the mast, the top of the console cable should be located at the top of the mast. Detach and discard lead wire.

DContinue step 2 on next page.



LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES

LS780T_Rev.1.3.indd 8-9

6/2/08 4:40:27 PM

Page 5
Image 5
Horizon Fitness LS780T manual E a S S E M B LY, Open Hardware Bag