INTRODUCTION IMPORTANT PRECAUTIONS
P R E - A S S E M B LY
note: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware. Any grease, such as lithium bike grease is recommended.
A S S E M B LY STEP 1
A S S E M B LY STEP 2
BLUE HARDWARE BAG CONTENTS : | A Open BLUE HARDWARE BAG. | |
BOLT (D) | B Connect the CONSOLE WIRES | |
20 mm | from the CONSOLE to those from | |
Qty: 2 | ||
the top of the MAST. | ||
|
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
CONDITIONING TROUBLESHOOTING LIMITED
GUIDELINES & MAINTENANCE WARRANTY
PINK HARDWARE BAG CONTENTS :
BOLT (A) | SPRING WASHER (B) | ARC WASHER (C) |
15 mm | 8 mm DIAMETER | 8 mm Diameter |
Qty: 6 | Qty: 6 | Qty: 6 |
CONSOLE MAST |
|
SPRING WASHER (B) |
|
BOLT (A) | WASHER (C) |
| CONSOLE WIRES |
BASE FRAME |
|
AOpen PINK HARDWARE BAG.
BConnect the CONSOLE WIRES from the BASE FRAME to the bottom of the CONSOLE MAST.
CAttach LEFT CONSOLE MAST using 3 BOLTS (A), 3 SPRING WASHERS (B) and 3 ARC WASHERS (C).
DRepeat on other side.
*Note: Be careful not to pinch any wires while assembling the masts.
SUGGESTED METHOD FOR STARTING BOLT |
CONSOLE |
BOLT (D) |
CONSOLE WIRES |
CUP HOLDER |
CAttach CONSOLE to the CONSOLE MASTS using 1 BOLT (D).
DRepeat on other side.
ETighten all console bolts.
FSnap each of the CUP HOLDERS firmly into the CONSOLE.
*Note: Be careful not to pinch any wires while assembling the console.
ASSEMBLY
BEFORE YOU BEGIN
TREADMILL OPERATION
LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES
T4_T6_Rev.1.7.indd | 10/19/06 9:21:57 AM |
