Horizon Fitness T6, T4 manual S E M B Ly, Unpacking, Tools Included, Parts Included

INTRODUCTION IMPORTANT PRECAUTIONS

A S S E M B LY

IMPORTANT: READ THESE SAFETY INSTRUCTIONS BEFORE USE!

WARNING

DISPLAY (T6 SHOWN)

GRIP PULSE HANDRAILS

WATER BOTTLE HOLDER

HAND RAIL SLEEVE

HAND RAIL

CONSOLE SAFETY KEY PLACEMENT

CONSOLE MAST

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

During the assembly process of the treadmill there are several areas that special attention must be paid. It is very important to follow the assembly instructions correctly and to make sure all parts are firmly tightened. If the assembly instructions are not followed correctly, the treadmill could have frame parts that are not tightened and will seem loose and may cause irritating noises. There should be no side-to-side play in the console masts or any forward and back play in the console assembly or handlebars. If there is any play in these areas, the treadmill has not been properly assembled. To prevent damage to the treadmill, the assembly instructions must be reviewed and corrective actions should be taken.

UNPACKING

Place the treadmill carton on a level flat surface. It is recommended that you place a protective covering on your floor. Take CAUTION when handling and transporting this unit. Never open box when it is on its side. Unpack the unit where it will be used. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!

ON/OFF SWITCH

CIRCUIT BREAKER

POWER CORD

TRANSPORT WHEEL

HAND RAIL BASE COVER

TOOLS INCLUDED

MOTOR COVER

RUNNING BELT / RUNNING DECK

SIDE RAIL

ROLLER END CAP

REAR ROLLER

ADJUSTMENT BOLTS

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

CONDITIONING GUIDELINES

Before proceeding, find your treadmill’s serial number and model name located to the left of the on/off power switch and power cord and enter it in the space provided below.

5 mm Allen Wrench

6 mm T-wrench

8 mm T-wrench Screwdriver

PARTS INCLUDED

CONDITIONING GUIDELINES

TROUBLESHOOTING & MAINTENANCE

enter your serial number and model name in the boxes below:

SERIAL NUMBER:

MODEL NAME:

1 Safety Key

1 Console Assembly

1 Power Cord

4 Hardware Bags

2 Hand Rails

2 Hand Rail Base Covers

2 Console Masts

2 Cup Holders

2 Hand Rail Sleeves

TROUBLESHOOTING & MAINTENANCE

LIMITED WARRANTY

*Refer to the serial number and model name when calling for service.

*Also enter this serial number on your Warranty Card.

If you have questions or if there are any missing parts, contact Customer Tech Support.

Contact information is located on the back panel of this manual.

For a complete exploded diagram, visit us at www.horizonfitness.com



LIMITED WARRANTY

T4_T6_Rev.1.7.indd 6-7 10/19/06 9:21:53 AM