Hoshizaki 73183 B. Important Notes for Component Replacement, C. Door Re-Hinging, will be lost

B. Important Notes for Component Replacement

CAUTION

When replacing a component listed below, see the notes to help ensure proper operation.

Component		Notes
Compressor	Install a new start relay, start capacitor, and compressor overload (compressor overload
	is integrated with the start relay on refrigerators; internal on 1-section freezers; external on
	2-section freezers).
Compressor,	WARNING! To reduce the risk of electric shock, be sure to reconnect the
Evaporator	component's ground wire.
Fan Motor,
Condenser Fan
Motor
Expansion Valve	• Attach the expansion valve bulb to the suction line in the same location as the previous
	bulb.
	• Secure the bulb with the clamp and holder, then insulate it.
Defrost	After working with or around the defrost thermistor on a freezer, make sure the defrost
Thermistor	thermistor wire is not touching the defrost heater.
Control Module	If three dashes (- - -) appear on the display module when energized, the compressor and
	display module are off. To turn the compressor and display module on, press and hold
	the upper and lower buttons until the temperature appears on the display. CAUTION! The
	three dashes must be cleared, otherwise the compressor will not run and product
	will be lost.

C. Door Re-Hinging

This unit is provided with a cabinet design which, after being delivered to the installation location, permits changing of the door swing from left to right or right to left. To change the door swing, an HS kit from your local Hoshizaki distributor is required. See the table below. CAUTION! Improper installation of the HS kit may result in the doors not closing completely and/or the gaskets not sealing correctly. For further details, contact your local Hoshizaki distributor or Hoshizaki Technical Support at 1-800-233-1940.

Convert	HS Kit Number
Right Hinge to Left Hinge	HS-3725
Left Hinge to Right Hinge	HS-3726

40