Hoshizaki KM-1400SWH/3-M Connection to an Open Drain System, Water-CooledCondenser

Models: KM-1400SWH/3-M

1 24
Download 24 pages 21.57 Kb
Page 15
Image 15
2. Water-Cooled Condenser

2. Water-Cooled Condenser

a) Connection to an Open Drain System

Condenser water supply inlet is 1/2" female pipe thread (FPT). A minimum of 3/8" nominal copper water tubing is recommended for the condenser water supply line.

A condenser water supply line shut-off valve and drain valve should be installed.

Condenser drain outlet is 3/8" FPT. A minimum of 3/8" nominal hard pipe is recommended for the condenser drain line.

In some areas, a back flow preventer may be required in the cooling water circuit.

In order to maintain the proper high side pressure, the condenser water supply inlet temperature should not drop below 45°F (7°C) and the condenser drain outlet temperature must be in the 104°F to 115°F (40°C to 46°C) range. Once the icemaker installation

is complete, confirm the condenser drain outlet temperature 5 minutes after a freeze cycle starts. If the condenser drain outlet temperature is not in the proper range, use a flat blade screwdriver to rotate the adjustment screw on the water‑regulating valve until the temperature is in the proper range (rotate counterclockwise to raise temperature or clockwise to lower temperature).

Icemaker

 

Water Supply

 

Inlet

 

1/2" FPT

 

Condenser Water

 

Supply Inlet

 

1/2" FPT

 

Condenser

 

Drain Outlet

 

3/8" FPT

 

Icemaker

Bin

Drain Outlet

 

3/4" FPT

 

Condensation

 

Drain Outlet

 

3/8" OD Hard Tube

 

Minimum 3/8" Nominal Hard Pipe

Minimum 3/8" Nominal Copper Water Tubing

Minimum 1/2" Nominal Copper Water Tubing

Icemaker Water Supply Line

Shut-Off Valve

Icemaker

 

Icemaker Water Supply Line

 

Drain Valve

Vent Tube

Condenser Water Supply Line

 

Shut-Off Valve

 

Condenser Water Supply Line

 

Drain Valve

Minimum

Separate piping to approved drain.

3/4" Nominal

Leave a 2-inch (5-cm) vertical air

Hard Pipe

gap between the end of each pipe

 

Vent Tube

and the drain.

 

2-inch (5-cm) air gap

Bin Drain Outlet

See Manufacturer's Instructions

Floor Drain

Fig. 9

KM-1400SWH/3-M

 

Connection to an Open Drain System

15

Page 15
Image 15
Hoshizaki KM-1400SWH/3-M instruction manual Water-CooledCondenser, a Connection to an Open Drain System