22)Move the control switch to the "WASH" position.
23)Replace the front panel in its correct position.
24)Turn on the power supply to rinse off the cleaning solution.
25)Turn off the power supply after 5 minutes.
26)Remove the front panel and the insulation panel.
27)Remove the drain plug. Allow the water tank to drain. Replace the drain plug and the insulation panel in their correct positions.
Note: Do not replace the insulation panel when you proceed to "2. Sanitizing Procedure."
28)Repeat steps 16 through 27 three more times to rinse thoroughly.
Note: If you do not sanitize the icemaker, go to step 9 in "2. Sanitizing Procedure."
2.Sanitizing Procedure - Following Cleaning Procedure
1)Dilute 2.5 fl. oz. (74 ml or 5 tbs) of a 5.25% sodium hypochlorite solution (chlorine bleach) with 5 gal. (19 l) of warm water.
2)Pour the sanitizing solution into the water tank.
3)Replace the insulation panel and the front panel in their correct positions.
Note: Make sure the control switch is in the "WASH" position and the cleaning valve is open.
4)Turn on the power supply to start the sanitizing process.
5)Turn off the power supply after 15 minutes.
6)Remove the front panel and the insulation panel.
7)Remove the drain plug. Allow the water tank to drain. Replace the drain plug and the insulation panel in their correct positions.
8)Repeat steps 16 through 27 in "1. Cleaning Procedure" two times to rinse thoroughly.
9)Close the cleaning valve.
10)Move the control switch to the "ICE" position.
11)Replace the front panel in its correct position.
12)Clean the storage bin liner using a neutral cleaner. Rinse thoroughly after cleaning.
13)Turn on the power supply to start the automatic icemaking process.
21
