CAUTION
Before operating the icemaker, the bin control thermostat assembly must be installed correctly. Failure to properly install the assembly could result in ice backup and unit damage.
5)Install the bin control thermostat.
a.Remove the baffle from the bin.
b.Remove the tie securing the bin control thermostat assembly. Then, remove the thumbscrew and the "Z" bracket.
c.Remove the bin control thermostat assembly from the shipping hook by lifting it up and shifting it to the right. Lower the thermostat extension bracket (stainless) with the thermostat bulb attachment and thermostat bulb through the hole located at the bottom of the icemaker. Next, lower the thermostat bracket (plastic) through the hole.
d.Slide the left side of the upper part of the assembly towards you and make sure it
is hooked on the wall. Make sure the left side and bottom of the assembly are flush against the wall and base panel.
e. Secure the assembly in place with the thumbscrew (unless you are installing a second unit).
f. Insert the plug into the receptacle on the assembly until it locks in place.
Wall | Bin Control Thermostat Assembly |
Shipping Hook |
|
Thermostat Bracket | Plug |
(plastic) |
|
Tie | Thermostat Extension | |
Bracket (stainless) | ||
| ||
Thermostat Bulb | Receptacle | |
Attachment (plastic) |
| |
and Thermostat Bulb | "Z" Bracket |
Thumbscrew
Hole
Fig. 3
Hook Bushing
Thumbscrew
15