Hoshizaki KM-1800SAH/3, KM-1800SRH/3, KM-1800SWH/3 instruction manual J. Startup

J. Startup

CAUTION

1.All parts are factory-adjusted. Improper adjustments may result in failure.

2.If the unit is turned off, wait for at least 3 minutes before restarting the icemaker to prevent damage to the compressor.

3.Do not operate the unit in the "WASH" position without water in the water tank. This will cause damage to the water pump seal.

1)Open the water supply line shut-off valve.

2)Remove the front panel.

3)Move the control switch on the control box to the "ICE" position.

4)Replace the front panel in its correct position.

5)Turn on the power supply, and allow the water tank to fill with water and the icemaker to operate for a total of 10 minutes.

Note: If miswiring causes excessive voltage on the controller board, the high voltage cut-out shuts down the circuit in 3 seconds and the icemaker automatically stops. When the proper supply voltage is resumed, the icemaker automatically starts running again.

6)Turn off the power supply, and remove the front panel.

7)Remove the insulation panel. Remove the cap located on the front bottom part of the ice dropping hole. Drain the water tank. See Fig. 15.

8)Replace the cap, insulation panel and front panel in their correct position.

9)Clean the storage bin.

10)Turn on the power supply, and start the automatic

icemaking process.

Fig. 15

26