4. ABNORMAL ICE
PROBLEM | POSSIBLE CAUSE | REMEDY | ||
[1] Small Cube | a) Ice Cube Guide | 1. | Out of position. | 1. Place in position. |
|
|
| Circulated water falls into |
|
|
|
| bin. |
|
| b) See chart 1 - [5], and check water supply line, Water | Solenoid Valve, water system, | ||
| Pump Motor or Controller Board. |
| ||
| c) Drain Valve | 1. | Dirty. | 1. Clean. |
[2] Cloudy or | a) See chart 2 - [1] and - [3], and check Float Switch, Water Solenoid Valve, | |||
irregular cube | Controller Board, Spray Tubes, water system, refrigerant charge or Expansion | |||
| Valve. |
|
|
|
| b) Spray Guide | 1. | Dirty. | 1. Clean. |
| c) Water Quality | 1. | High hardness or contains | 1. Install a water filter or |
|
|
| impurities. | softener. |
5. OTHERS
PROBLEM | POSSIBLE CAUSE |
| REMEDY | ||
[1] Icemaker will | a) Bin Control | 1. | Set too cold. | 1. | Adjust warmer. |
not stop when | Thermostat | 2. Defective. | 2. Replace. | ||
bin is filled |
|
|
|
|
|
with ice. |
|
|
|
|
|
[2] Abnormal | a) Pump Motor | 1. | Bearings worn out. | 1. Replace. | |
noise | b) Fan Motor | 1. | Bearings worn out. | 1. Replace. | |
|
| 2. | Fan blade deformed. | 2. | Replace fan blade. |
|
| 3. | Fan blade does not move | 3. Replace. | |
|
|
| freely. |
|
|
| c) Compressor | 1. | Bearings worn out, or | 1. Replace. | |
|
|
| cylinder valve broken. |
|
|
|
| 2. | Mounting pad out of | 2. Reinstall | |
|
|
| position. |
|
|
| d) Refrigerant Lines | 1. | Rub or touch lines or other | 1. | Replace. |
|
|
| surfaces. |
|
|
[3] Ice in storage | a) Bin Drain | 1. Plugged. | 1. | Clean. | |
bin often |
|
|
|
|
|
melts. |
|
|
|
|
|
44