10)Slightly loosen the outer 2 thumbscrews.
11)Slide the thumbscrews into the slots on the bin control bracket. The bin control bracket is located on the back wall of the icemaker.
Thumbscrews
Slots
10 | 11 |
CAUTION
If a gap is left between the bin control and the wall of the dispenser, ice may get between them and damage the bin control. Therefore, make sure there is no gap.
12)Make sure the bin control is flush with the dispenser unit/storage bin wall, then tighten the 2 thumbscrews.
13)Pull the bin control lead so that there is no slack in the ice drop area, then secure the hose that the lead runs through with a cable tie.
Evaporator | To Control |
Bin Control Lead | Box |
|
Cable Tie | Plastic Pipe |
12 | Hose |
14)Replace the tank in the icemaker and reconnect the 4 hoses.
15)Replace the front frame and insulation in their correct positions and secure with the thumbscrews.
16)Replace the panels in their correct positions.
15
