Installation Instructions
ROLLERS
The rollers have 3 purposes:
■Rollers adjust so the door closes easily
when opened about halfway. (Raise the front about 5/8″ [16 mm] from the floor.)
■Rollers adjust so the refrigerator is firmly positioned on the floor and does not wobble.
■Rollers allow you to move the refrigerator away from the wall for cleaning.
Final leveling adjustments should be made after the refrigerator has been installed.
To adjust the rollers on 23′ models:
Remove the base grille by opening the doors, removing the screws at each end, and pulling it straight out.
Turn the front roller adjusting screws clockwise to raise the refrigerator, counterclockwise to lower it. Use
a 3/8″ hex socket |
|
Roller adjusting screws | |
or wrench, or an |
|
| |
adjustable wrench. |
|
These models also have rear adjustable rollers so you can align the refrigerator with your kitchen cabinets. Use a long- handled 5/16″ socket wrench to turn the screws for the rear
Replace the base grille.
DOOR ALIGNMENT
After leveling, make sure that the refrigerator door is 1/16″ higher than the freezer door.
To align the doors, adjust the refrigerator door.
Using a 7/16″ socket wrench, turn the door adjusting screw to the right to raise the door, to the left to lower it. (A nylon plug, imbedded in the threads of the pin, prevents the pin from turning unless
a wrench is used.)
After one or two turns of the wrench, open and close the refrigerator door and check the alignment at the top of the doors.
Refrigerator door
needs to be raised.
To remove the base | 7/16″ Socket |
grille, open the doors, | Wrench |
remove the screw at |
|
each end of the base |
|
grille and then pull |
|
the grille straight out. | Raise |
25
