WARNING – THIS APPLIANCE MUST BE | Positioning the Cooker |
| GB | |
|
| |||
|
|
| ||
EARTHED . |
|
|
| The height of the |
Electrical connection |
|
|
| cooker can be |
|
|
| adjusted by means | |
|
| mm | 150 mm | of adjustable feet in |
Electric cookers come without a power supply | 650 |
| the plinth (900mm - | |
150 mm |
| |||
cable. The cooker is designed to operate on an |
|
| 915mm). Adjust the | |
electricity supply which conforms to the electrical |
|
| feet by tilting the | |
data shown on the Rating Plate. Some cookers can |
|
| cooker from the side. | |
be connected to the mains only after removing the |
|
| Then install the | |
back panel of the cooker itself with a screwdriver*. |
|
| product into position. | |
N.B.: the following installation procedure must be |
|
| NOTE: This appliance | |
carried out by a qualified electrician. The electrical |
|
| must not be fitted on | |
installation must comply with the IEE Regulations, |
|
| a platform. | |
Building & local |
|
|
| The cooker is |
For the installation of the feeding cable carry out the | Moving the Cooker |
| designed to fit | |
following operations: |
|
|
| between kitchen |
1 | Open the terminal |
|
| cabinets spaced |
|
| 500mm apart. The | ||
board by inserting a |
|
| space either side | |
screwdriver into the |
|
| need only be | |
side tabs of the cover. |
|
| sufficient to allow | |
Use the screwdriver as |
|
| withdrawal of the | |
a lever by pushing it |
|
| cooker for servicing. | |
down to open the cover |
|
| It can be used with | |
(see diagram). |
|
| cabinets one side or | |
|
|
|
| both as well as in a |
2 | Loosen the cable |
|
| corner setting. It can |
|
| also be used free- | ||
clamp screw and |
|
| standing. | |
remove it, using a |
|
| Adjacent side walls | |
screwdriver as a lever |
|
| which project above | |
(see figure). |
|
| hob level, must not | |
3 | Slacken the wire |
|
| be nearer to the |
cooker than 150mm and should be protected by heat | ||||
contact screws | resistant material. Any overhanging surface or | |||
then fasten the wires | cooker hood should not be nearer than 650mm. | |||
under the screw heads, |
|
|
| |
respecting the colour | Before moving your cooker check that it is cool, and | |||
code: Black/Blue (N), | switch off at the cooker control unit. | |||
Red/Brown (L) and |
|
|
| |
Bare |
| Movement of your cooker is most easily achieved by | ||
|
| lifting the front as follows: |
|
z Once the connections have been made, tighten | Open the grill door sufficiently to allow a comfortable | |
grip on the underside front edge of the oven roof, | ||
all the terminal screws fully. | ||
avoiding any grill elements. | ||
|
z Fasten the supply cable in place with the clamp and close the cover of the terminal board.
*Concerns certain models only
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24 | 5 |
|