If something

goes wrong...

Before calling a Service Engineer, please check through the following lists.

THERE MAY BE NOTHING WRONG.

 

 

 

GB

 

 

 

 

 

 

 

 

 

 

Problem

 

Check

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Slight odour or

 

 

 

 

 

 

 

 

small amount of

 

 

 

 

 

 

 

 

smoke when grill /

This is normal and should cease after a short period.

 

 

oven used for first

 

 

 

 

 

 

 

time

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

If you find that the timer display is blank, then it is likely that there is no electricity supply to

 

 

 

 

 

your oven. Check:

 

 

 

 

 

Nothing works

 

(i) That the main cooker wall is switched on

 

 

 

 

 

 

 

(ii) Other appliances, to see if you have had a power cut

 

 

 

 

 

(iii) The main circuit breaker for the property

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Operating the cooker under the following conditions may cause a safety device to operate:

 

 

Top oven, grill and

(a) Grilling with the door closed - Always grill with the door fully open

 

 

main oven do not

 

(b) Grilling for an excessively long period at maximum setting - see Grilling guide.

 

 

work.

 

Switch off appliance and allow to cool for approx 30 mins.

 

 

 

 

 

Switch the cooker back on and check that the Grill / Top oven is now operating.

 

 

 

 

 

 

 

 

 

 

Grill keeps turning

When the Grill control is operating at less than its maximum setting, the Grill will cycle on

 

 

on and off

 

and off, this is normal and not a fault.

 

 

 

 

 

 

 

 

 

 

 

 

 

Timer Display is

 

The power supply to your oven has possibly been interrupted, but has now come back on

 

 

 

again. Reset the timer to the correct time and "Manual" operation using the instructions given

 

 

flashing '0.00

'

 

 

in the timer section of the book.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Oven temperatures

Check temperature and shelf positions are as recommended in the Oven Temperature

 

 

Charts.

 

 

 

 

 

too high or low

 

 

 

 

 

 

 

It may be necessary to increase or decrease the recommended temperature slightly to suit

 

 

 

 

 

 

 

 

 

 

your taste.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Oven does not

 

Check:

 

 

 

 

 

 

(a)

Temperature and shelf positions are as recommended in the Oven Temperature Charts.

 

 

cook evenly

 

 

 

 

(b)

Oven utensils being used allow sufficient air flow around them.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The oven is not

 

 

 

 

 

 

 

 

working and

 

Your appliance has developed a fault which will require assistance from our service

 

 

showing F01 to F68

department.

 

 

 

 

 

code in the display

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Problem

 

 

Possible causeS

olution

 

 

 

The “Clock button” and the

The appliance has just been

Set the clock.

 

 

 

digits on the display flash.

connected to the electricity

 

 

 

 

 

 

 

 

 

mains or there has been a blackou

 

 

 

 

 

A programmed cooking mode

There has been a blackout.R

eprogram the cooking mode.

 

 

 

does not start.

 

 

 

 

 

 

 

Only the high luminosity

The appliance is in standby mode

Press any button to exit

 

 

 

“Clock button” is lit.

 

standby mode.

 

 

 

An automatic mode has been

The temperature inside the oven

Wait for the oven to cool down.

 

 

 

 

selected. “Hot” appears on the

is higher than the suggested value

 

 

 

 

 

display and cooking does not start

for the selected mode.

 

 

 

 

 

Fan-assisted cooking has been

Positions 1 and 5: the direct

We recommend switching

 

 

 

selected and the food looks burnt.

heat could cause

dripping pan positions halfway

 

 

 

 

 

 

 

temperature-sensitive

through cooking.

 

 

 

 

 

 

 

foods to burn.

 

 

 

 

 

 

 

 

 

 

 

 

 

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

25

Page 25
Image 25
Hotpoint DX 1032 CX S manual If something Goes wrong, There MAY be Nothing Wrong