D ISHWASHER
Fault Area | Issue | Cause/How to resolve… |
Rinse Aid Light Flashing/ | Rinse Aid light will flash if:- | |
Not Going Out When Rinse | - | YouareusingtheMachine for |
Aid Added |
| the first time. |
|
| Or |
| - | The rinse aid level is low. |
TheRinse Aidlightwillflashwhen yourdishwasherisswitchedonfor
Please Note:
-The rinse aid light will remain lit after the rinse aid has been added, and will continue to flash until the machine has completed the next full wash cycle (Note: The Fast & Prewash cycles are not full wash cycles).
-If you are using 3 in 1 tablets (or 2 in 1) and do not add rinse aid then the rinse aid light will flash continuously.
Leaking From Rear Of | PossibleIncorrectFitmentofWater | Check |
|
|
| |
Machine | InletHose | Isthewaterinlet hoseconnectionsecuredatrearofmachine(Fig1) | ||||
|
|
| and has filter washer (A) been fitted (Fig2)? | |||
|
| Machine Connection |
| Tap Connection | ||
|
|
|
|
|
|
|
Fig.1
Filter washer (A) can be found with the Instruction Bookwhenthemachine is delivered.
Fig.2
Cycle Indicator Lights | Your dishwasher is designed so that if a fault occurs, an error message indicated by one |
Flashing | or two wash cycle indicator lights flashing rapidly. |
| In many cases you can rectify these errors by following instructions in this section. |
| Ifhowevertheerrorsindicatedonyourmachinearenotlisted,youwillneedtocontactyourServiceCentre |
| for assistance. |
| See “Key Contacts” on the back page of the instruction book. |
Short beeps sounding for - | Turnonthewatertapandthedishwasherwillstartafterafew |
a few minutes when starting | minutes. |
programme. |
|
- Watertapturnedoff |
|
16