![The Dishwasher Will Not](/images/new-backgrounds/56376/5637639x1.webp)
D ISHWASHER
Fault Area | Issue | Cause/How to resolve… |
Poor Drying Results | Is Rinse Aid being used or is the |
| Rinse Aid level set too low? |
Using rinse aid in your wash will improve the drying performance.
To add rinse aid to your wash follow instructions below:
Step 1: Rotate cap
Step 2: Pour rinse aid into container and secure cap back into position.
&DS
The Dishwasher Will Not | PossibleInstallationFault |
Drain | (Particularlyifthemachineisbeing |
| usedforthefirsttime) |
The level of rinse aid used during your wash cycle can be adjusted to ensurebestresults.
Rinse Aid Levels 1 (lowest) to 6 (Highest)
Rinse Aid level adjuster is located under dispenser cap. Using small coin rotate adjustertodesiredsetting.
(Werecommendsettingto4).
RinseAidAdjuster
Check
-Is the drain hose kinked?
-Is the sink trap blocked? (If this is the case you will experience problems whit your sink drainage).
-Ensuretheblankingplug/closedendconnector hasbeenremoved ifconnectedtoasinktrap(thisisthemostcommonfaultwheninstalling
a dishwasher).
Ensure drain
hose is not
kinked
Remove blanking
plug/closed end connection from sink trap.
Note:
Therearetwotypesofsinktrap
drainhoseconnection.
1.Closedendconnection:
Which must be cut off.
2.Blanking plug in the sink trap connections:
Which must be removed.
20