D ISHWASHER
Troubleshooting
In the unlikely event that you have problems with your machine, the following guide will enable you to resolve many problems without having to call out a service engineer.
Fault Area | Issue | Cause/How to resolve… |
The Dishwasher Will Not Start
Possible Installation/Electrical SupplyFault
(Particularly if the machine is being used for the first time)
Cycle phase indicator lights flashing:
- Hastimedelaybeenselected?
Check
-Isthedishwasherpluggedinandswitchedon?
-Is there a power failure, check to see if other appliances working.
-Checkthefuse.
-Isthereafaultwiththewatersupply/isthewatersupplytapturnedon?
-Isthewaterpressuresupplysufficient?
-Is the inlet hose kinked?
-Isthedoorclosedproperly?
Ifadelayedstarthasbeenselectedthenthecyclephaseindicatorlight correspondingtothelenghtoftimedelayedwillflash.
For example:- |
|
Pre wash flashing | - 3hr Delay Set |
Wash | - 6hr Delay Set |
Rinse | - 9hr Delay Set |
Drying |
Salt Refill Light Flashing/
Not Going Out When Salt
Added
Delay Start
Button
Salt refill light will flash if:-
-YouareusingtheMachine for the first time
Or
-The salt level is low
Follow the instructions below to cancel:-
Step 1: Press the “Delay Start” Button until all light are out.
Step 2:Selectwashprogrammeasnormal.
Please Note: The “Drying” light will also flash to indicate the end of a programme. (See “Cycle Phase Indicator Lights Flashing”below).
TheSaltrefilllightwillflashwhenyourdishwasherisswitchedonforthe
PleaseNote:
-The salt refill light will remain lit after the salt has been added for several consecutive cycles.
-If you are using 3 in 1 tablets and do not add salt then the salt refill light will flash periodically for several consecutive cycle.
-If 3 in 1 dishwasher tablets are used we still recommend that you add salt to prevent limescale deposits on your dishes.
15