Hotpoint RB533, RB526, RB536, RB632 Anti-Tip Bracket Installation, Leveling the Range, Final Check

8 Anti-Tip Bracket Installation

An Anti-Tip bracket is supplied with instructions for installation in a variety of locations. The instructions include a template, a parts list and a list of tools necessary to complete the installation. Read the Important Safety Information and the instructions that fit your situation before beginning installation.

WARNING

■Range must be secured by Anti-Tip bracket supplied.

■See instructions to install (supplied with bracket).

■Unless properly installed, the range could be tipped by stepping or sitting on the door. Injury might result from spilled hot liquids or from the range itself.

Bracket

Wall plate

Screw must enter wood or metal

Typical installation of anti-tip bracket attachment to wall.

9 Leveling the Range

The range must be level. Leveling feet are located at each corner of the base of the range. Remove the storage drawer or kick panel (depending on your model) and using channel locks, rotate the leveling feet in and out as required to level the range. (For instructions on how to remove and replace the storage drawer or the kick panel, see the Care and cleaning of the range section.)

On some models, there are plastic covers which may be removed for easy adjustment (just squeeze and pull).

One of the rear leveling feet will engage the Anti-Tip bracket (allow for some side to side adjustment). Allow a minimum clearance of 1/8″ between the range and the leveling foot that is to be installed into the Anti-Tip bracket.

Check the range for proper installation into the Anti-Tip bracket by removing the kick panel or storage drawer and inspecting the rear leveling leg. Make sure it fits securely into the slot.

10 Final Check

Be sure all range controls are in the OFF position before leaving the range.

Safety Information Operating Instructions Installation Instructions Troubleshooting Tips Customer Service

35