Hotpoint RGB535, RGB628 Care And Cleaning, Care and, Sealed Burner Assemblies on some models

CARE AND CLEANING

Proper care and cleaning are important so your range	BE SURE ELECTRICAL POWER IS
will give you efficient and satisfactory service. Follow	DISCONNECTED BEFORE CLEANING ANY
these directions carefully in caring for it to help assure	PART OF YOUR RANGE.
safe and proper maintenance.

CAUTION: DO NOT OPERATE THE BURNER WITHOUT ALL BURNER PARTS AND DRIP PANS (IF SO EQUIPPED) IN PLACE.

Sealed Burner Assemblies (on some models) Burner Heads (on sealed burners only)

Broiling

Grate

Burner cap

Drip pan

(on some models)

Burner head

Electrode

Turn all controls OFF before removing the burner parts and drip pans (if so equipped).

The burner grates, caps, burner heads and drip pans (if so equipped) can be lifted off, making them easy to clean.

The electrode of	Electrode
the spark igniter is

exposed when the burner head is removed. When one

burner is turned to LITE, all the burners spark. Do not attempt to disassemble or clean around any burner while another burner is on. An electric shock may result, which could cause you to knock over hot cookware.

For proper ignition, make sure the small hole in the section that fits over the electrode is kept open. A sewing needle or wire twist-tie works well to unclog it.

The slits in the burner heads of your range must be kept clean at all times for an even, unhampered flame.

You should clean the surface burners routinely, especially after bad spillovers, which could clog these openings.

To remove burned-on food, soak the burner heads in a solution of mild liquid detergent and hot water for 20- 30 minutes. For more stubborn stains, use a toothbrush.

Before putting the burner head back, shake out excess water and then dry it thoroughly by setting it in a warm oven for 30 minutes.

Replace the burner caps. Make sure that caps are replaced on the correct size burner. There is one small, 2 medium and one large cap.

NOTE: On some models the caps are all the same size and can be used in any of the 4 needed locations.

Care and

Burner Caps (on sealed burners only)
Lift off when cool. Wash burner caps	small
in hot, soapy water and rinse with
clean water. You may scour with a	medium
plastic scouring pad to remove
burned-on food particles.	large
Dry them in a warm oven or with a
cloth—don’t reassemble them wet.	NOTE: On some models the caps
Replace the burner caps.	are all the same size and can be
Make sure that caps are replaced on	used in any of the 4 needed
the correct size burner. There is one	locations.

small, 2 medium and one large cap.

medium

medium

small

large

Front of Range

(continued next page)

Cleaning

23