Hotpoint RGB508, RGB628, RGB535 Questions? Before You Call For Service…, Installation Instructions

QUESTIONS?

BEFORE YOU CALL FOR SERVICE…

PROBLEM	POSSIBLE CAUSE
TOP BURNERS DO NOT	• Make sure electrical plug is plugged into a live power outlet.
LIGHT OR DO NOT	• Burner holes on the side or around the top of burner may be clogged. Remove
BURN EVENLY
	burners (on models with standard twin burners) or burner heads (on models
	with sealed burners) or burner caps on spill-proof models, and clean them
	with a sewing needle or twist-tie. Make sure you do not enlarge the holes. On
	spill-proof models, check electrode area for burned-on food or grease.
	• Make sure the drip pans are installed correctly.
	• Pilot(s) is (are) not lit (on standing pilot models). See the Lighting Instructions
	for Standing Pilot Models section in Surface Cooking.
BURNER FLAMES VERY	• If range is connected to LP gas, contact the person who installed your range
LARGE OR YELLOW	or made the conversion.
SURFACE BURNERS	• The oven gas shut-off valve may have accidentally been moved during
LIGHT BUT OVEN	cleaning or moving.
DOES NOT	To check the oven gas shut-off valve on standard twin burner models, raise
	the cooktop and look for the gas shut-off lever at the extreme right rear corner.
	(Standing pilot models do not have a gas shut-off valve on the regulator.)
	Follow the directions in box A or B that match your regulator type.
		A	B

Lever shown closed.	Lever shown closed.
	PULL TO OPEN.
PULL TO OPEN.
Standard Twin Burner Models	Standard Twin Burner Models

To check the oven gas shut-off valve on sealed burner models, remove the storage drawer, broiler drawer or kick panel and look for the gas shut-off lever at the back of the range.

Follow the directions in box A or B that match your regulator type.

A B

Lever shown closed. PULL

TO OPEN.

Lever shown closed. PULL

TO OPEN.

Sealed Burner Models Sealed Burner Models

(continued next page)

41

Installation Instructions

Before You Call for Service