HP h9-1440t, 120-1000z, 120-1031 Remote control, Memory card reader, Symptom, Possible solution

Remote control

Symptom

Remote sensor is not receiving a signal from the remote control.

Possible solution

￿Be sure to point the remote control at the sensor.

￿Be sure the remote control has fresh batteries.

￿For an external sensor with a USB connector, try enabling the IR connection by following these steps:

1Click the Start button.

2Type Device Manager into the Start Search box, and then click Device Manager to open the Device Manager window.

3Click the plus sign (+) next to Universal Serial Bus controllers.

4If eHome Infrared Receiver is listed under Universal Serial Bus Controllers, Windows 7 is properly detecting the

IR receiver. If it is not listed, go to the next step.

5Unplug the end of the USB cable on the remote sensor from the computer, and then plug it back into the same USB connector.

6Disconnect all other USB devices, leaving the remote sensor connected, and then restart the computer. Connect other USB devices after the remote sensor appears in the Device Manager window.

Memory card reader

Symptom	Possible solution
Memory card reader	Do not insert or remove memory cards when the in-use (activity)
cannot read the	light is flashing. Doing so may cause data loss or permanent
memory card.	damage to the card reader.
	Some memory cards have a Read/Write or a Security switch.
	Ensure the switch is set to Write Enabled before you attempt to
	write data to the card.
	Ensure the amount of stored data does not exceed the storage
	limit of the memory card.

44Getting Started (features vary by model)