2.Disconnect the display panel cable (2) and the control cable (3) from the system board.
3.Remove the 7 Phillips PM2.5×4.0 screws (1) that secure the display assembly to the computer.
4.Rotate the computer upward to open the display hinges, and then separate the display from the computer (2).
5.If it is necessary to remove the clutch cover or the display hinges:
a.Remove the clutch cover (the plastic piece on the bottom of the display) by pulling it straight up to disengage it (1).
b.Remove the 4 Phillips PM2.5×5.0 screws (2 from each hinge) that secure the hinges to the display.
c.Remove the antennas and the control cable from the left hinge (2).
Component replacement procedures | 35 |
