Installing the Switch
Installation Procedures
2.Check the LEDs on the switch. The LED behavior is described below.
Port LEDs
Power LED
When the switch is powered on, it performs its diagnostic self test. The self test takes approximately 8 seconds to complete.
Self Test LED Behavior:
During the self test:
•The LEDs will go on for a couple of seconds during the phases of the self test.
When the self test completes successfully:
•The Power LED stays on.
•The Fault LED stays off.
•In the default state, the FDx LED stays on and the Spd LED stays off.
•The port LEDs on the front of the switch go into their normal operational mode.
–If the ports are connected to active network devices the Link LEDs should be on.
If the LED display is different than what is described above, the self test has not completed correctly. Refer to chapter 4, “Troubleshooting” for diagnostic help.