HP 2000 Base Model manual Securing the RP2 to a counter top

Securing the RP2 to a counter top

1.Turn off the computer properly through the operating system, then turn off any external devices.

2.Disconnect the power cord from the power outlet.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to the internal components of the computer.

3.Tilt the display head back (1), and then push the neck of the stand back to a full vertical position

(2) to access the screw holes on the base of the stand.

NOTE: It takes some force to push the neck of the stand back to the vertical position. Hold the base securely with one hand while forcing the neck back with the other hand.

4.There are two screw holes on the base of the stand. Fasten the stand to the counter top using the appropriate fastening devices (not provided by HP) for your surface.

28 Chapter 2 Hardware upgrades