HP AdvanceStack Router 245 Phase 3: Prepare the Router Hardware, Figure 1-19.Example of Power and Self-TestLED Positions for Single-HeightModels

	Installation
	Phase 3: Prepare the Router Hardware
	If the router is not in the factory default state when you apply power, it
	configures itself according to the configuration that was most recently
	saved.
N o t e	The router does not have a power switch. The router is powered on
	when you plug in the power cord, and automatically adapts to the
	correct ac voltage range for your power source.

1.Plug the power cord into the router’s power socket and into an ac power source.

2.Check these LEDs on the back of the router:

∙Power LED is continuously lit.

∙Self-test LED:

–lights during the self-test that automatically occurs after you power on or boot the router

–turns off after a minute or two (when the self-test completes and the router boots)

If either LED operates differently, refer to chapter 3, “Troubleshooting”

Power and

Self-Test

LEDs

Figure 1-19. Example of Power and Self-Test LED Positions for Single-Height Models

Installation 1

1-23