1 | Macintosh Direct Connect START HERE |
This side of the poster covers Macintosh direct connect setup. See reverse side for Windows.
Network setup is covered on the other poster. Make sure you use the correct poster and CD.
| 2 | Attach front panel cover |
|
|
|
aRemove any packaging material.
bPlace the front panel cover over the buttons. Firmly press on the sides to snap the cover in place. Make sure all the buttons are visible.
cLift the display.
3 Load paper
Use blank white paper to prepare for print alignment.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
a |
| b |
| c |
| d |
|
|
|
|
| 4 | Connect phone cord |
|
|
|
aYou must connect the supplied phone cord to the phone jack on the left
b To connect an answering machine or use your own phone cord, see the Fax Setup chapter in the Reference Guide.
Connect power cords |
|
|
|
| 6 | Connect USB cable |
|
| |
|
|
|
Do not connect the USB cable to a keyboard.
7 | Turn HP device on |
|
Turn power on. Wait for the print cartridge message to appear, and then continue.
series all-in-one
8 | Insert print cartridges |
|
9 Align print cartridges
Press OK on the front panel to begin alignment. After a page prints, alignment is complete. Discard or recycle this page.
Direct Connect (USB) setup poster
2500 photosmart
a Lift the print carriage door up | b Remove the bright pink tape | c Hold the black print cartridge with the | d Press down on the gray latch | |
| until it catches. Lift the blue | from both print cartridges. Do | label on top as shown. Slide the | until it locks into place. Insert |
| and gray latches. | not touch the | cartridge underneath the metal bar | the color cartridge on the left |
|
| contacts or retape the | into the right (gray latch) side of the | side, and lock into place. |
|
| cartridges. | print carriage. |
|
|
|
|
|
|
|
|
|
|
|
eMake sure both latches are locked into position. Close the door.
Macintosh
hp psc
10 Install software
aTurn on your Macintosh and wait for it to finish starting up. Insert the HP PSC Macintosh CD.
b | c Follow the onscreen |
instruction. Make sure you | |
your desktop. | complete the Setup |
| Assistant. |
11 Congratulations!
You are ready to begin using your HP PSC. See the Reference Guide to get started.