HP 2575v, 2575xi manual Printer Not Found screen appears during installation

(continued)

The Printer Not Found screen appears during installation

The Ethernet cable is not plugged in to the router, switch, or hub, or the cable is defective.

Solution: Try reinserting the cables. Or, if necessary, try a different cable.

The HP All-in-One is assigned an AutoIP address instead of DHCP.

Solution: This indicates that the HP All-in-One is not connected properly to the network.

Check the following:

●Make sure all cables are connected properly and securely.

●If the cables are connected properly, your access point, router, or home gateway may not be sending an address. If this is the case, you might need to reset the device.

●Make sure your HP All-in-One is on the correct network.

The HP All-in-One is on the wrong subnet or gateway.

Solution: Print a network configuration page, and verify that the router and HP All- in-One are on the same subnet and gateway. For more information, see View and print network settings.

The HP All-in-One is not turned on.

Solution: Turn on the HP All-in-One.

Network setup

User Guide 41