HP 3Com 3C905B D7505A D7505A, 3Com 3C905B D7504A D7504A manual Software Installation Procedure

CAUTION

Windows 95 Users

Windows 98 Users

HP 10/100 3Com 3C905B-TX Network Interface Card Installation Guide

Software Installation Procedure

Software Installation Procedure

Make sure that you have installed the network interface card before you install the network driver software.

Software Installation on a Windows 95 or Windows 98 System

To install the network driver when your PC is running Windows 95:

1Start the PC. Windows 95 will automatically detect a new PCI Ethernet Controller.

2Insert EtherDisk® diskette #1 in your drive and click on Next.

3The 3Com Fast Etherlink XL 10/100Mb TX Ethernet NIC (3C905B-TX) driver files will be automatically found, click on Finish to complete the driver installation.

4If prompted to insert EtherDisk® diskette #1, type A:\ at the Copy Files From prompt and press ENTER. Similarly, insert EtherDisk® diskette #2 and press ENTER when prompted.

5Follow the onscreen instructions. If prompted, enter the location of the Windows 95 files (CAB files) then click on OK. On HP Windows 95 preloaded systems, the path is C:\WINDOWS\OPTIONS\CABS.

6Click on Finish to complete the network component installation.

7If Windows prompts you to reboot, remove your driver diskette and click on Yes. The software installation is complete. Follow the instructions on page 11 to confirm your installation.

To install the network driver when your PC is running Windows 98:

1Start the PC. Windows 98 will automatically detect a new PCI Ethernet Controller. Click on Next to begin the installation.

2Select Search for the Best Driver and click on Next.

3Select Floppy Disk Drives only, insert EtherDisk® diskette #1 in your drive and click on Next.

10 English