|
| HP 10/100 3Com |
|
| Software Installation Procedure |
| 6 | When prompted to start searching for a network adapter, click on |
|
| Select from List... |
| 7 | In the Select Network Adapter window, click on Have Disk... |
| 8 | Insert EtherDisk® diskette #1 in your drive and type A:\ at the |
|
| prompt, then press ENTER. |
| 9 | In the OEM Option window, highlight 3Com Fast Etherlink/Etherlink XL PCI |
|
| BusMaster NIC and click on OK, then click on Next. If you are in the |
|
| Network control panel window, click on Close and follow the |
|
| instructions from step 14 onwards. |
| 10 | Select the Network Protocols that are used by your LAN and click on |
|
| Next. |
| 11 | Select the Network Services that should be used by your PC when |
|
| connected to your LAN and click on Next. |
| 12 | Click on Next to begin the software installation with the settings you |
|
| have provided. |
| 13 | Follow the onscreen instructions, if you are prompted for network |
|
| information, enter the information supplied by your MIS department. |
| 14 | Enter the location of the Windows NT 4.0 files (CAB files) when |
|
| prompted, then click on OK. On HP Windows NT 4.0 preloaded |
|
| systems, the path is C:\i386. |
| 15 | When prompted to reboot, remove your driver diskette and click on |
|
| Yes. The driver and network software installation is complete. |
|
| |
CAUTION | If a service pack was already installed on the PC before the network | |
| interface card was installed, the service pack must be reinstalled. This | |
| will overcome the At Least One Service Failed to Start error when Windows NT | |
is started.
On some platforms you also need to reinstall certain drivers after installing the Service Pack. Refer to your PC documentation for more information.
English 13
