HP 3Com 3C905B D7504A D7504A, 3Com 3C905B D7505A D7505A Installing the Network Interface Card

WARNING

HP 10/100 3Com 3C905B-TX Network Interface Card Installation Guide

Installing the Network Interface Card

Installing the Network Interface Card

For your safety, never remove the PC’s cover without first removing the power cord, data cables and any connection to a telecommunications network. Always replace the cover before switching on again.

For complete information on how to install an accessory card, refer to your PC’s documentation. This is available from your PC’s support web site (refer to page 18.) The following steps are given as a guide:

1With the PC turned off, disconnect the power cord and any connection to a telecommunications network, and then remove the cover.

2Choose an empty PCI slot. If you do not know how to identify a PCI slot, refer to your PC’s documentation.

3Remove the metal slot cover.

4Depending on the PC model, you may need to remove the accessory slot’s retaining bracket. Refer to your PC’s documentation, if necessary.

5Insert the card into the accessory slot without bending it.

Example position of

WOL connector.

6Connect the Remote Wake-Up cable to the connector on the card and to connector on the system board or backplane.

For the position of the Remote Wake-Up connector, refer to “3C905B-TX NIC Specifications” on page 19.

Refer to your PC’s documentation for the position of the connector on the system board or backplane.

English 7