NOTE
HP 10/100 3Com
HP Support Services
The PC Cannot Be Started or Woken-Upfrom the Network
1If the PC has been powered off (for example, due to an electrical power failure, or because the power cord has been removed), the Remote Power On (RPO) will not work. To enable the RPO, you must first power on the PC, allow the Operating System to boot, then shut down the PC.
2Check that the WOL connector cable is connected to the network interface card and to the PC’s system board.
3Check that the
RPO is only supported under Windows 95, Windows 98 and Windows NT 4.0.
HP Support Services
The latest drivers and utilities are available on HP’s Web site at:
For HP Vectra PCs | www.hp.com/go/vectrasupport |
For HP Brio PCs | www.hp.com/go/briosupport |
For HP Kayak PC | www.hp.com/go/kayaksupport |
Workstations |
|
18 English