Reverse this procedure to install the USB board.
Power connector cable
Description | Spare part number |
|
|
Power connector cable | |
|
|
Before removing the power connector cable, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.
4.Remove the battery (see Battery on page 43), and then remove the following components:
●Memory module/wireless module compartment cover (see WLAN module on page 44)
●Hard drive (see Hard drive on page 48)
●Keyboard (see Keyboard on page 53)
●Top cover (see Top cover on page 56)
●Speakers (see Speakers on page 63)
●USB board (see USB board on page 65)
Remove the power connector cable:
1.Close the computer.
2.Turn the computer upside down, with the front toward you.
3.Disconnect the power connector cable (1) from the system board.
66 | Chapter 4 Removal and replacement procedures |