Card reader board
Description | Spare part number |
|
|
Card reader board for use in 4530s models | |
|
|
Card reader board for use in 4730s models | |
|
|
Before removing the card reader, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then unplugging the AC adapter from the computer.
4.Remove the battery (see Battery on page 47).
5.Remove the following components:
a.Bottom door (see Bottom door on page 49).
b.Optical drive (see Optical drive on page 50)
c.Keyboard (see Keyboard on page 63)
d.Top cover (see Top cover on page 65)
Remove the card reader:
1.Position the top cover
2.Remove the tape that secures the cable to the Touchpad button board (1).
3.Disconnect the cable from the connector on the Touchpad button board (2).
4.Remove the two Phillips PM2.5×5.0 screws (3) that secure the card reader board to the top cover.
NOTE: Screw position may vary.
70 Chapter 4 Removal and replacement procedures
