HP 522a (AP), 703k (AP), 743a (AP) manual To connect the network interface adapter to the network

This network connection also allows you to share printers, data, and other devices among your PCs.

Note: Your computer may not come with a network interface adapter.

Locate the RJ-45 port on the back of the computer. (Refer to the illustration that matches your system.)

RJ-45 port

To connect the network interface adapter to the network:

1Plug the network cable into the RJ-45 port on the network adapter. The port is located on the back of the computer.

Note: Do not connect a telephone cable (RJ-11 connector) to the network adapter port (RJ-45).

2Plug the other end of the network cable into a 10BaseT or a 100BaseT port on the network hub.

Note: The hub is a device to which all computers on

the network are connected.
Warning: DO NOT plug the network
cable into a telephone jack. Although the	Internet
are not the same.
plug on the network cable looks similar
to the plug on a telephone cable, they

3With the computer turned on, check the LEDs (light-emitting diodes) on the network adapter. The LEDs on each type of network adapter are described below. (Refer to the illustration that matches your system.)

Quick Start Guide 33